Aquatic Access IGAT-180 AD Manuale di installazione / Manuale di istruzioni - Pagina 11

Sfoglia online o scarica il pdf Manuale di installazione / Manuale di istruzioni per Sistemi di sollevamento Aquatic Access IGAT-180 AD. Aquatic Access IGAT-180 AD 16. Pool lift
Anche per Aquatic Access IGAT-180 AD: Manuale di installazione / Manuale di istruzioni (18 pagine)

Stampa la pagina

REPLACEMENT OF THE PISTON AND/OR THE TOP GUIDE

1. Follow directions for Disassembly of Lift and Replacement of Piston Seal, steps 1-3.

2. Remove piston from end of piston rod using a rubber or plastic mallet. Go to step 5 of this

section if you are only replacing the piston and not replacing the top guide.

3. Remove old top cylinder bushing and replace with new top cylinder bushing. Note that the

threaded holes in the top bushing are off center. The holes need to be positioned so that they are

towards the top of the lift. (See illustration)

4. Install spacer on piston rod. Clean spacer if it is dirty.

5. Install piston on end of piston rod using a rubber or plastic mallet. Hit bottom of piston until

piston is firmly seated. Piston should be able to rotate freely after being attached. (See detail in

illustration

6. Go to step 6 of Disassembly of Lift and Replacement of Piston Seal and continue through step

11.

REPLACEMENT OF RUB BLOCK

1. Follow directions for Disassembly of Lift and Replacing Piston Seal.

2. Insert a small block of wood or plastic between piston rod and piston frame to spread apart.

(See illustration)

3. Remove rub block. Install new rub block. (See illustration for orientation of rub block.)

4. Go to step 6 of Disassembly of Lift and Replacement of Piston Seal and continue through step

11.