Accurate Technology Pro-60 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura Accurate Technology Pro-60. Accurate Technology Pro-60 12. Wood moisture meter

ON/OFF BUTTON: When the meter is off, momentarily pressing then releasing

this button will cause the meter to turn ON, and briefly display the firmware

version, then enter Measurement Mode.

To turn OFF the meter, depress the ON/OFF button momentarily, then release. The

meter will also turn itself off automatically when not in use as described in the auto-

shutdown section.

HOLD BUTTON: When the meter is in Measurement Mode, and the button is

momentarily depressed, it will enter Hold Mode to allow the user to "freeze" the

moisture content reading. Hold Mode is selected when the symbol "÷" appears in the

left corner of the display.

This function is ideal for keeping a moisture reading on the display when you are taking

moisture readings in hard-to-reach places. The reading will be "frozen" on the display

until you press and release the Hold button again.

SPECIES BUTTON: The species setting can be changed to compensate for a

variety of wood species. Refer to the species table included with your meter to

locate the correct species setting for your wood. If your material is not listed, refer to

the "Species Corrections" portion of this manual. The values entered into the Pro-60

meter omit the decimal point, so for example the Douglas Fir value of 0.50 would be

"50" when programming the Species Setting Value.

The Pro-60 can store 3 different species settings at a time, which can be selected by

the Species Table Index value. Momentarily pressing the Species Button will cause

the display to show the current Species Table Index (Index value 1, 2, or 3), and the

species setting value (SG) for that index number.

AUTO-SHUTDOWN: The meter will automatically shutdown in 60 seconds anytime the

meter moisture content reading has not changed by more than 2%, and no meter

buttons have been pressed. The shutdown timer will reset anytime the meter reading

changes or a button has been pressed.

LOW BATTERY INDICATOR: If the meter is ON, and battery voltage is low, the LO

BAT indicator will be shown on the left side of the display. When the LO BAT indicator

is on, you must replace the battery or the meter may not function correctly. If the

battery needs to be replaced, use either a 9-volt alkaline or a ni-cad rechargeable. Be

sure to observe proper battery polarity.

Accurate Technology Pro-60

Page 4 of 12