Ayra ERO 540 MKII Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchio di illuminazione Ayra ERO 540 MKII. Ayra ERO 540 MKII 11. Rgb led movinghead

Additional information

Mounting the bracket

On the bottom of the movinghead, there are two holes to mount the included bracket, using the included

bolts. It is possible to mount a G-clamp or halfcoupler to this bracket. It is also possible to mount the bracket

on a ceiling, wall, bar, floor, desk or any flat surface. Use proper equipment to install this fixture, as a

dropping fixture may cause severe injury! Ayra is not responsible for any damage or injuries caused by

improper installation.

Focus

The ERO 540 MKII movinghead is equipped with an adjustable focus system. This focus system is

positioned directly below the lens and makes it possible to sharpen the projection of gobos and spot figures.

To adjust the focus for optimal projection results, you need a Phillips screwdriver. Only adjust the focus of the

movinghead when it is positioned in a static positioned (disconnected from the power supply or via DMX in a

static position).

Always support the head with your hand when tightening or loosening the screw for the focus system. Do

not touch the lens as this may cause fingerprints and negative influences on the output.

Loosen the screw with the screwdriver, until you are able to move the focus back and forth. Avoid loosenig

the screw too much as it is spring loaded. Choose the right position for the focus and after that, tighten it

again to fixate the focus in the current position.

See the images below for more information.