Cisco 4500-M Manuale di installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione per Interruttore Cisco 4500-M. Cisco 4500-M 18. Upgrading memory
Anche per Cisco 4500-M: Manuale di sostituzione (16 pagine), Manuale di aggiornamento (24 pagine)

Stampa la pagina

Removing the Component Tray from a Chassis with a Safety Latch

Warning

working near the power supply. Before starting any of these procedures, turn OFF power to the

system, unplug the power cord, disconnect any cables at the ports, and attach your ESD-preventive

wrist strap.

Take the following steps to remove the component tray from a chassis with a safety latch:

Step 1

Step 2

Step 3

Step 4

Figure 2

Rear of chassis

Warning

your work surface or with your hands to prevent it from falling (see Figure 2).

Step 5

Step 6

Hazardous voltages may exist in or near the power supply, so use extreme caution when

Turn OFF the system power.

Attach your ESD-preventive wrist strap.

Remove all network and power cables.

Loosen the nonremovable screw in the back of the router chassis. The screw is labeled

"Chassis release screw" in Figure 2.

Component Tray Removal for Chassis With a Safety Latch

Chassis shell

AUX

Before releasing the safety latch, support the component tray from underneath either on

Slide the component tray out of the chassis shell while facing the rear panel of the chassis,

pulling the handle on the right side of the chassis until the safety latch catches. (See

Figure 2.)

Supporting the component tray with one hand, push down on the safety latch tab while you

pull out on the component tray.

Preparing the Chassis for Rack-Mounting or Wall-Mounting

Safety latch tab

Chassis release

screw

CONSOLE

INPUT 100-240VAC

Hand supporting

component tray

Cisco 4000 Series Rack-Mount and Wall-Mount Installation

50/60HZ 3.0-1.5 AMPS

Handle