Cisco ASR 920 series Manuale di installazione - Pagina 27

Sfoglia online o scarica il pdf Manuale di installazione per Interruttore Cisco ASR 920 series. Cisco ASR 920 series 42. Aggregation services router
Anche per Cisco ASR 920 series: Manuale di installazione (36 pagine), Come iniziare (6 pagine), Manuale di installazione dell'hardware (46 pagine), Manuale (36 pagine)

Installing the Cisco ASR 920 Series Router

Perform the following procedure to ground the router using a 2-hole lug and the corresponding mounting

point. Most carriers require a minimum 6-AWG ground connection. Verify your carrier's requirements for

the ground connection.

SUMMARY STEPS

1. If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch

(12.7 mm ±0.5 mm) (See the figure below).

2. Slide the open end of your 2-hole ground lug over the exposed area of the ground wire.

3. Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the ground

wire as shown in the figure below.

4. Use a Phillips head screwdriver to attach the 2-hole ground lug and wire assembly to the router with the

2 pan-head Phillips head screws.

5. Connect the other end of the ground wire to a suitable grounding point at your site.

DETAILED STEPS

Step 1

If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch (12.7 mm ±0.5

mm) (See the figure below).

Figure 21: Stripping a Ground Wire

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

Install the Chassis Ground Connection