Siemens SMI50E56EU Manuale di istruzioni per l'uso - Pagina 22

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Lavastoviglie Siemens SMI50E56EU. Siemens SMI50E56EU 40.

en
Operating the appliance

Switching off the appliance

Short time after the end of the
programme:
1. Switch off ON/OFF switch (.
2. Turn off the tap (not applicable if
Aqua-Stop fitted).
3. Remove the utensils when they have
cooled down.
Note
When the programme ends, leave
the appliance to cool down a while
before opening it. This will prevent
steam from escaping and causing long-
term damage to your built-in furniture.

Interrupting the programme

1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
2. To continue the programme, switch
on the ON/OFF switch ( again.
T erminating the programme
T e r m i n a t i n g t h e p r o g r a m m e
(Reset)
1. Press START button @ for
approx. 3 sec.
The numerical display H
indicates :
2. The programme sequence lasts
approx. 1 min. On the digital
display H is indicated :
3. Switch off ON/OFF switch (.
22
.
.

Changing the programme

When the START button @ has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).

Intensive drying

The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Caution if utensils are delicate!)
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press and hold down the START
button @.
4. Rotate programme selector 8
until :
is indicated on the digital
display H.
5. Release button.
The factory-set value :
the digital display H (intensive
drying off).
Change the setting as follows:
1. By rotating the programme selector
8, you can switch intensive drying
on :
or off :
2. Press START button @.
The set value is saved.
is lit on
.