ABB ACQ580-01 Series Manuale di installazione e avviamento rapido - Pagina 11

Sfoglia online o scarica il pdf Manuale di installazione e avviamento rapido per Azionamenti in corrente continua ABB ACQ580-01 Series. ABB ACQ580-01 Series 17. Ul type 4x (ip66) drives, nec types
Anche per ABB ACQ580-01 Series: Manuale (16 pagine), Manuale di installazione e avviamento rapido (16 pagine), Manuale di installazione e avviamento rapido (17 pagine)

13. Install optional modules, if included in the delivery

14. Install the cover(s)

The cover installation procedure is the opposite of the removal procedure. Refer to

install the side plates shown in

15. Start up the drive

WARNING! Before you start up the drive, make sure that the installation is completed. Make sure also that it is safe

to start the motor. Disconnect the motor from other machinery if there is a risk of damage or injury.

WARNING! If you activate the automatic fault reset or automatic restart functions of the drive control program,

make sure that no dangerous situations can occur. These functions reset the drive automatically and continue

operation after a fault or supply break. If these functions are activated, the installation must be clearly marked as

defined in IEC/EN 61800-5-1, subclause 6.5.3, for example, "THIS MACHINE STARTS AUTOMATICALLY".

Use the control panel to do the start-up procedure. The two commands at the bottom of the display show the functions of

the two softkeys

and

depending on the context. Use the arrow keys

active view. Key

shows a context-sensitive help page.

Power up the drive. Make sure that you have the motor name plate data available.

The First start assistant guides you through the first start-up.

The assistant begins automatically. Wait until the control panel shows

the language selection screen.

Select the language you want to use and press

Note: After you select the language, it takes a few minutes for the

control panel to wake up.

Select Start set-up and press

To complete the first start assistant, select the values and settings

when prompted by the assistant. Continue until the panel shows that

the first start is complete.

When the panel shows that the first start is complete, the drive is ready

for use. Press

(Done) to enter the Home view.

The Home view shows the values of the selected signals.

Connection procedure

before you install the cover.

located below the display. The commands assigned to the softkeys are different

(Next).

Remove the

and

to move the cursor or change values depending on the

(OK).

cover(s). In frames R6...R9,