Cisco AIR-LAP1310G Istruzioni per il montaggio - Pagina 19

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Punto di accesso wireless Cisco AIR-LAP1310G. Cisco AIR-LAP1310G 40. Cisco aironet 1300 series lightweight outdoor access point

Stampa la pagina

1. Mounting the Access Point

Mounting the Access Point

To mount the access point on a tower, follow these steps:

Step 1

Choose a mounting location on the tower for the access point. If you are using the integrated antenna,

the mounting location must provide a clear signal path to the remote access point. For more information,

see

Step 2

Find a suitable mounting support or install a mounting pole for the access point. The mounting bracket

accommodates poles from 1.25 to 2.75 inches (30.5 to 69.9 mm) in diameter; the supplied U bolts fit

1.25 to 1.75-inch poles only. You can find this type of hardware at http://www.rohnnet.com.

Hoist the access point assembly to the mounting location. The mounting brackets have openings for

Step 3

hoisting the unit.

Attach the access point to the mounting pole using appropriate hardware (see

Step 4

information, see the

Point the antenna as accurately as possible in the direction of the remote antenna. The integrated antenna

Step 5

is correctly positioned when the flat face of the radome faces the remote antenna.

Warning

Caution

Note

Find the building's grounding electrode system and then connect the access point ground lug to it using

Step 6

6 AWG copper wire. Use a crimping tool to crimp the wire to the ground lug. For more information about

attaching the ground lug to the access point, see

to the Access Point" section on page

Routing the Cables for Lightning Protection

In areas where lightning strikes are common and when the access point is mounted high on the tower,

ground the shields of the RG6 coaxial cables to the tower at regular intervals. This precaution helps

protect the access point and power injector from lightning damage. The recommended spacing between

grounds is 200 ft (60 m). In areas of especially high lightning risk, space the grounds even closer.

78-17634-01

"Choosing a Mounting Location" section on page

"Assembling the Mounting Hardware" section on page

This equipment must be grounded. Never defeat the ground conductor or operate the

equipment in the absence of a suitably installed ground conductor. Contact the appropriate

electrical inspection authority or an electrician if you are uncertain that suitable grounding

is available. Statement 1024

To ensure correct installation and grounding, install the access point in compliance with your

local and national electrical codes: National Fire Protection Association (NFPA) 70, National

Electrical Code (U.S.); Canadian Electrical Code, Part I, CSA 22.1 (Canada); and if local or

national electrical codes are not available, refer to IEC 364, Part I through Part 7 (other

countries).

Local code may require grounding of the tower mount.

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Step 3

and

Step 4

28. See

Figure 11

for the ground lug location.

Mounting the Access Point

Figure

6). For more

26.

in the

"Attaching the Housing Bracket