argon audio TT2OPT Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Giradischi argon audio TT2OPT. argon audio TT2OPT 12.

Changing replay speed

To play records at 45 r.p.m. first remove the platter (5). Using the accessory tool

provided (3a), hook the belt (3) over the larger diameter part of the motor pulley (2).

Refit the platter. To revert to 33,33 r.p.m. repeat the proceedings using the smaller

step on the pulley.

Fitting and connecting the cartridge

** All cartridges with half inch mounting holes can be fitted. Leaving the needle's

protection cover on, fit the cartridge to the headshell using the screws supplied with

the cartridge by passing one screw through each slot in the headshell (21). Do not

tighten the nuts yet.

Connect the tonearm wires to the cartridge pins as follows:

white

left channel positive (L+)

red

right channel pos. (R+)

green

right channel return (R -)

blue

left channel return (L -)

The full sound quality of the Argon Audio TT2 can only be achieved if the cartridge is

correctly adjusted.

If you are not well acquainted with the adjustment of cartridges you are advised to call

upon the willing help of your Argon Audio dealer to accomplish this task for you.

Adjusting the azimut

** The cartridge needle must be vertical in the record groove in

order to trace the groove wall modulations correctly.

A small screw at the bearing end of the arm allows incorrect

azimut to be corrected if your needle is not mounted exactly

perpendicular to the cartridge body (which is often the case).

Slacken off the screw just enough to be able to revolve the

arm tube without applying force. Note! Do not remove the

screw completely!

With the aid of a good magnifying glass adjust the needle until it is vertical in the

groove (i.e. perpendicular to the record's surface). Ideally this should correspond to

the top surface of the cartridge body being parallel to the record surface. When you

are satisfied that the needle is vertical retighten the screw carefully.

Under no circumstances should the arm tube be adjusted with the needle still in the

record groove! Irreparable damage may be caused to the cantilever suspension! The

arm must be lifted to make each adjustment and lowered afterwards to check it.

w w w . a r g o n a u d i o . c o m

T T 2