Cisco UCS B200 M3 Nota di installazione e manutenzione - Pagina 7

Sfoglia online o scarica il pdf Nota di installazione e manutenzione per Server Cisco UCS B200 M3. Cisco UCS B200 M3 28. Blade server
Anche per Cisco UCS B200 M3: Manuale di installazione (34 pagine), Nota di installazione e manutenzione (36 pagine), Nota di installazione e manutenzione (37 pagine), Manuale (8 pagine), Manuale di aggiornamento (21 pagine)

Procedure

Step 1

If you are local to the server, check the color of the Power Status LED for each server in the chassis that you want to

power off.

• Green indicates that the server is running and must be shut down before it can be safely powered off. Go to Step 2.

• Amber indicates that the server is already in standby mode and can be safely powered off. Go to Step 3.

Step 2

If you previously enabled front power-button control through Cisco UCS Manager, press and release the Power button,

then wait until the Power Status LED changes to amber.

The operating system performs a graceful shutdown and the server goes to standby mode.

Caution

To avoid data loss or damage to your operating system, you should always invoke a graceful shutdown of the

operating system.

Step 3

(Optional) If you are shutting down all blade servers in a chassis, disconnect the power cords from the chassis to completely

power off the servers.

Step 4

Remove the appropriate servers from the chassis.

Removing a Blade Server

Using UCS Manager, decommission the server before physically removing the server. To remove a blade server from the chassis,

follow these steps:

Procedure

Step 1

Loosen the captive screws on the front of the blade.

Step 2

Remove the blade from the chassis by pulling the ejector lever on the blade until it unseats the blade server.

Step 3

Slide the blade part of the way out of the chassis, and place your other hand under the blade to support its weight.

Step 4

Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately reinstalling it into another

slot.

Step 5

If the slot is to remain empty, install a blank faceplate (N20-CBLKB1) to maintain proper thermal temperature and keep

dust out of the chassis.

Installing a Half-width Blade Server

Before you begin

The blade server must have its cover installed before installing the server into the chassis to ensure adequate airflow.

Procedure

Step 1

Grasp the front of the blade server and place your other hand under the blade to support it.