Cisco UCS B200 M4 Nota di installazione e manutenzione - Pagina 7

Sfoglia online o scarica il pdf Nota di installazione e manutenzione per Server Cisco UCS B200 M4. Cisco UCS B200 M4 30. For e5-2600 v4 series cpus
Anche per Cisco UCS B200 M4: Nota di installazione e manutenzione (46 pagine), Manuale di aggiornamento (9 pagine), Manuale di manutenzione (24 pagine)

Installing the Storage Module

Procedure

Step 1

Place the storage module over the two standoff posts on the motherboard at the front of the server.

Step 2

Press down on the drive bay cage where it is labeled "Press Here to Install" until the storage module clicks into place.

Figure 5: Storage Module

Step 3

Using a Phillips-head screwdriver, tighten the four screws to secure the storage module. The locations of the screws are

labeled "Secure Here."

The RAID storage module has two front-accessible drive bays that support hot-swappable, 2.5 inch drives. If you purchased the UCS

B200 M4 blade server without the storage module configured as a part of the system, a pair of blanking panels (UCSB-LSTOR-BK)

may be in place. These panels should be removed before installing a hard drive, but should remain in place to ensure proper cooling

and ventilation if the drive bay is unused .

You can remove and install blade server hard drives without removing the blade server from the chassis.

The drives supported in this blade server come with the drive sled attached. Spare drive sleds are not available. A list of currently

supported drives is in the specification sheets at:

http://www.cisco.com/en/US/products/ps10280/products_data_sheets_list.html