Cisco IP/VC 3526 Manuale di informazioni sulla sicurezza - Pagina 41

Sfoglia online o scarica il pdf Manuale di informazioni sulla sicurezza per Porta d'ingresso Cisco IP/VC 3526. Cisco IP/VC 3526 50. Pri gateway
Anche per Cisco IP/VC 3526: Note di rilascio (6 pagine)

Cisco IP/VC 3526 Manuale di informazioni sulla sicurezza
EMC Environmental Conditions for Products Installed in the
European Union
This section applies to products to be installed in the European Union.
The equipment is intended to operate under the following environmental conditions with respect to
EMC:
In addition, if equipment is operated in a domestic environment, interference may occur.
EMC Class A Notices and Warnings
This section includes the EMC Class A warnings for the Cisco IP/VC 3500 products.
Class A Notice for FCC
Modifying the equipment without Cisco's authorization may result in the equipment no longer
complying with FCC requirements for Class A digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to
radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case users will be
required to correct the interference at their own expense.
Class A Notice for Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
78-14912-03
A separate defined location under user's control.
Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.
AC power distribution shall be one of the following types, where applicable: TN-S and TN-C as
defined in IEC 364-3.
Regulatory Compliance and Safety Information for Cisco IP/VC 3500 Products (Release 3.0 and Release 4.0)

EMC Environmental Conditions for Products Installed in the European Union

41