EPSON Stylus Scan 2000
6. Place the color cartridge into its holder with the labels
facing up and toward the back of the printer. Then press
down the clamp until it locks into place.
7. Press the R cleaning button. The print head moves to the
left so you can install the black ink cartridge.
8. Lift up the black ink cartridge clamp.
9. Place the black cartridge into its holder with the labels
facing up and toward the back of the printer. Then press
down the clamp until it locks into place.
WARNING:
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets in your eyes, flush them immediately with water.
10. Press the R cleaning button to begin charging the ink
delivery system and close the front cover.
Charging takes about 2 minutes. The P power light flashes
Charging takes about 2 minutes. The
Charging takes about 2 minutes. The
Charging takes about 2 minutes. The
and the printer makes various sounds until it's finished.
and the printer makes various sounds until it's finished.
and the printer makes various sounds until it's finished.
and the printer makes various sounds until it's finished.
Don't turn off the printer or interrupt the charging process
Don't turn off the printer or interrupt the charging process
Don't turn off the printer or interrupt the charging process
Don't turn off the printer or interrupt the charging process
or it will start over, using more ink than necessary. Charging
or it will start over, using more ink than necessary. Charging
or it will start over, using more ink than necessary. Charging
or it will start over, using more ink than necessary. Charging
is finished when the P power light stops flashing and stays
is finished when the
is finished when the
is finished when the
on.
on.
on.
on.
Caution:
Never turn off the printer while the
unless the printer hasn't moved or made any noise for more than 5
minutes.
6 - EPSON Stylus Scan 2000
power light flashes
power light flashes
power light flashes
power light stops flashing and stays
power light stops flashing and stays
power light stops flashing and stays
P
power light is flashing,
Loading Paper
1. Open the output tray and its extensions. Slide the edge
guide out until it is a little wider than your paper.
2. Load a stack of paper with the printable side up and place it
against the right side of the feeder. Then slide the edge
guide up against the paper's left edge. Don't load paper
higher than the arrow on the guide.
Slide the edge
guide against
the paper.
Testing the Printer
You can run a printer operation check to determine whether
the problem comes from the printer or some other source.
If the results are satisfactory, the problem lies in your
software settings, the interface cable, or your computer.
If the check page does not print correctly, you have a
problem with your printer. See the User's Guide for possible
solutions.
1. Make sure both the printer and computer are turned off.
2. Disconnect the interface cable from the printer.
3. Make sure paper is loaded in the printer.
Caution:
Load paper that's at least 8.27 inches (210 mm) wide. This
prevents ink from spraying inside the printer and smudging your
printouts.
4. Hold down the E load/eject button and press the P power
button. Hold down the E load/eject button until the
P power light starts to flash, then release it.
The printer prints its ROM version number and a nozzle
check pattern (shown in "Running a Nozzle Check" on
page 10).
5. To end the check, turn off the printer. Then reconnect the
interface cable and turn on your printer and computer.
9/99
If the paper has a
corner cut, make sure
you load it as shown
Stampa la pagina