Aries FilterWorks HPL-RO Manuale di installazione e assistenza - Pagina 4
Sfoglia online o scarica il pdf Manuale di installazione e assistenza per Sistemi di filtrazione dell'acqua Aries FilterWorks HPL-RO. Aries FilterWorks HPL-RO 7. Reverse osmosis system
Stampa la paginaSystem Diagram:
Use good plumbing practices when installing the system. Isolation valves are recommended for
system isolation and maintenance. Connection to the Aries FilterWorks High Purity Water
system will be done only after the HPL-RO has been properly flushed.
System Set Up and Installation:
The system should be set up according to the diagram above. The tubing connections are labeled
for easy installation. Follow all local plumbing codes for correct installation.
DO NOT TURN ON THE WATER SUPPLY UNTIL AFTER ALL CONNECTION
HAVE BEEN MADE
1. Attach a 1/4" OD tube from the cold water supply to the FEED system inlet.
2. Attach a 1/4" OD tube to the DRAIN connection. The other end of the tube should be
connected to a drain or sink for the membrane reject water to flow. An air gap must
be left in this drain line so waste water does not back up into the membrane.
3. Connect the 3/8" OD tube from the TANK outlet on the RO system to the connection
on the RO storage tank assembly.
4. Connect a 3/8" OD tube from the RO-WATER connection on the RO system
assembly to polishing system.
5. DO NOT make the final connection to the polishing unit until the RO system and
cartridges have been properly flushed per the instructions below.
M-0221201113
Revision 4
Page 4 of 7