Yamaha ATS-1010 Manuale d'uso - Pagina 13
Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Yamaha ATS-1010. Yamaha ATS-1010 19. Front surround system
Anche per Yamaha ATS-1010: Manuale d'uso (20 pagine)
Stampa la pagina
TV remote
control operation
may be difficult
if the unit
hides the sensor of your TV when beneath or under the
TV. Try the two solutions
below and see whether
this
solves the problem.
@
Move
the unit in all directions.
@ Remove
the stands
to lower
the height
of
the unit.
Keep the stands and screws in a safe place for future use.
_
sing TV remote control relay
function
If you cannot solve the problem
by the suggestions
abo_,c,
follow the procedure
below
and use the TV remote
control relay l'unction,
which relays the TV remote
control signal received
at the front of the unit to the
remote
control sensor of your TV through
the TV remote
control signal transmitter
at the rear of the unit.
The remote
control sensor of
your TV
I
TV remote
control
signal
transmitter
L/_ 1
1
Set the unit to standby
mode.
2
Press both the VOLUME + button and _)
button of the main unit, release the
button first, then release the VOLUME +
button.
The unit is turned on when switching
the TV remote
control relay l'unction on/off.
The CLEAR
VOICE indicator
lights up as the
following
illustration.
Check if the setting is correct.
(_, P. 11 )
! !!i!: !i!!!
The (?LEAR
VOICE indicator
CLEAR VOICE
CLEARVOiCE
(for 2 seconds
[]
_ [],_
after
tile
tlnit
iS
* I _
turned on)
No light
Green
• The default
setting is off.
• You can verify the current
setting by turning the
unit on again from standby
mode.
• Move tlle unit in all directions again ifTV remote control
remains difficult.
• The TV remote control relay ffmction is enabled even if
tlle unit is in standby mode.
You can use the TV remote control solely to operate
by
having the unit learn the TV remote control operations.
You can operate
the following
functions
by TV remote
control.
• Volume
down
• Volume
up
•
Power on/standby
mode
Some TV remote controls may not control these functions.
Use the remote control supplied with the unit in this case.
1
Set the unit and
TV to standby
mode.
2
Press
both the INPUT
button
and
_)
button
of the main
unit,
release
the
(_
button
first,
then
release
the INPUT
button.
The unit enters the remote control
iNPUT
learning
mode.
%=.,
Flashes in
red
Continued
to the next page. ,,*
9 En