Zanussi ZFU20200WA Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Congelatore Zanussi ZFU20200WA. Zanussi ZFU20200WA 16.
Anche per Zanussi ZFU20200WA: Manuale d'uso (36 pagine)

Stampa la pagina

Storage of frozen food

When first starting-up or after a period out of

use, before putting the products in the com-

partment let the appliance run at least 2 hours.

The freezer drawers ensure that it is quick and

easy to find the food package you want. If large

quantities of food are to be stored, remove all

drawers except for the bottom drawer which

needs to be in place to provide good air circu-

lation. On all shelves it is possible to place food

that protrude until 15 mm from the door.

Important! In the event of accidental

defrosting, for example due to a power failure, if

the power has been off for longer that the value

shown in the technical characteristics chart

under "rising time", the defrosted food must be

consumed quickly or cooked immediately and

then re-frozen (after cooling).

Thawing

Deep-frozen or frozen food, prior to being used,

can be thawed in the refrigerator compartment

or at room temperature, depending on the time

available for this operation.

Small pieces may even be cooked still frozen,

directly from the freezer: in this case, cooking

will take longer.

Removal of freezing baskets and glass

shelves from the freezer

Some of the freezing baskets have a limit stop

to prevent their accidental removal or falling

out. At the time of its removal from the freezer,

pull the basket towards yourself and, upon

reaching the end point, remove the basket by

tilting its front upwards

At the time of putting it back, slightly lift the

front of the basket to insert it into the freezer.

Once you are over the end points, push the

basket back in their position.

First use

Cleaning the interior

Before using the appliance for the first time,

wash the interior and all internal accessories

with lukewarm water and some neutral soap so

The appliance is equipped with shelf stops to

secure the shelves.

The shelves must be lifted up (1) on each side

and than pulled outwards (2).

The glass shelves equipped with expander roll-

ers are secured with locking pins.

To remove them proceed as follow:

1. Use a screwdriver to loosen the locking pin

on each side on the expander roller.

2. Then pull out both locking pin (1).

3. Then pull the glass shelf outwards (2).

as to remove the typical smell of a brand-new

product, then dry thoroughly.

Important! Do not use detergents or abrasive

powders, as these will damage the finish.