Alecto WS-4800 Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Stazione meteorologica Alecto WS-4800. Alecto WS-4800 17. Weather station with wireless outdoor sensor
Anche per Alecto WS-4800: Manuale d'uso (16 pagine)

Stampa la pagina

7.2 To set Hi-Lo limits:

1. repeatedly press the

AL' next to it (if applicable)

2. use / to set the limit

3. briefly press the

4. press the

end automatically

7.3 Hi-Lo Alarm function setup:

1. repeatedly press the

AL' next to it (if applicable)

2. briefly press the button to enable or disable the selected alarm

7.4 Operation:

As soon as the set limit is exceeded, an alert tone will sound for up to 2 minutes while the concerned

display flashes and the alert indicator underneath the display flashes every 7 seconds. Briefly press the

button to stop the alert ton. The flashing stops automatically as soon as the concerned measurement

returns to within the set limits (or when you adjust the limit or disable the alarm function for the

concerned measurement).

8. RELATIVE AIR PRESSURE

8.1 Introduction:

When you're living considerable higher than the mean sea level, you'll be experiencing a lower air

pressure. To ensure that the weather forecast is still accurate, you'll need to correct the air pressure

according to your where you live.

8.2 Relative air pressure setup:

1. refer to the internet or your local authorities for information about your local air pressure

2. press and hold the

3. use / to select 'relative'

4. briefly press

5. use / to correct the display by setting it to the value you've obtained from your local authorities or

the internet

6. briefly press

9. PROBLEM SOLVING

Problems

No or strange measurements from the rain sensor

No or strange measurements from the thermometer and humidity

meter.

No or strange measurements of wind speed and wind direction.

---

and

(reception signal lost for 1 minute)

and

(reception signal lost for 1 hour)

button until the desired display is flashing with the indication 'HI AL' or 'LO

button again to save the value

button again to select the next display or wait several seconds for the setup mode to

button until the desired display is flashing with the indication 'HI AL' or 'LO

button for 2 seconds until 'absolute' or 'relative' starts flashing

and the air pressure display starts flashing

to save the air pressure

Solutions

• Check the drain in the rain meter; it must be opened.

• Check whether the rain meter sits horizontal.

• Check whether the air grooves are open.

• Check the sensor casing.

• Check the weather vane.

• Check the wind cups of the wind speed meter.

• Move the indoor unit closer to the outdoor unit.

• Make sure that the indoor unit is not placed near other

electronic equipment that might cause interference due to

wireless transmissions (TV, PC, microwave)

• When the problem remains, please reset both the indoor and

outdoor unit.