3Doodler Create+ Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Accessories 3Doodler Create+. 3Doodler Create+ 16.
Anche per 3Doodler Create+: Manuale d'uso (11 pagine)

Stampa la pagina

1. My Pen won't turn on!

Let's double check the following:

A. Is the Power Adapter plugged into a working power outlet?

NOTE:

If you have a spare power adapter around the house please

use it to test your 3Doodler Create+. This will help determine if

the problem is with your 3Doodler Create+ or with the Power

Adapter provided in the box.

B. Is the end of the Power

Adapter connected to the

correct part of the Pen?

2. My Plastic is extruding but it

Stop extruding and start

again using the following

instructions:

When the Plastic resumes

extruding, push the Nozzle

firmly down into the paper,

allowing Plastic to stick to the

surface.

Drag the Plastic along the

paper or surface in a continuous

unbroken line as if you were

writing with a pencil.

Keep your movement slow and

steady. The Plastic should hold

to the paper and not curl up

around the Nozzle.

3. My Plastic is not extruding from

3A. Plastic not engaging properly with the Drive Gear:

Gently push until you feel the strand pulled through the Drive

Gear on its own.

If the above does not work, reverse the Plastic fully from the Pen.

(See Section 2, Step 6) Snip ends, then reinsert and try again.

If Plastic is too short to be removed from the Pen, move to 3B.

3B. Plastic is too short to be removed from the Pen:

Try unscrewing the Nozzle and

using the Unblocking Tool.

While Pen is hot (BLUE or

GREEN Light on), use Mini

Spanner to unscrew and

remove Nozzle anti-clockwise.

While using the Reverse feature

of the 3Doodler Create+, insert

Unblocking Tool through open

front end of Pen and gently

push any excess Plastic out

through the back of the Pen.

3Doodler_Bob_User_Manual_MAIN_Inner_20180511.indd 9

(Light doesn't turn on)

won't stick to the paper, or is

curling up around the Nozzle.

my 3Doodler Create+.

C. Make sure the Control

Switch on your 3Doodler

Create+ is not set to OFF.

Mini

Spanner

Unblocking

Tool

BLUE

GREEN

Light

Blue or

Green

Light

11/5/2018 11:37 AM

3C. Plasti

around th

Remove M

using Min

provided

Use the M

or Unbloc

and releas

Drive Gea

through th

the Maint

from the P

4. My

aro

Nozzle m

continued

While Pen

GREEN Li

Nozzle clo

it using th

provided.

you first fe

to avoid o

Nozzle an

5. My

A. Click ei

B. If Step

3Doodler

6. Ho

unu

While the

either the

the Plasti

to remove

strand.

If Plastic i

7. I ha

can

It is possib

way out o

past the P

You will be

Maintena

Plastic re

contact w

Plastic is

For both o

• Insert a n

remaining

• While us

Nozzle an

the Pen. (S