3DS MAX Series Manuale d'uso - Pagina 2
Sfoglia online o scarica il pdf Manuale d'uso per Controllore 3DS MAX Series. 3DS MAX Series 11. Solar controller
Stampa la paginaSolar charge controller MAX series User Manual
Dear Clients,
Thank you for purchasing our MAX series solar controller. This product manual provides some
important advice related to the controller, including installation, programming and
troubleshooting. Please read this manual carefully before using this product.
1. Overview
Outstanding features:,
LCD display design, read operating data and
working condition easily.
12/24 automatic recognition.
Built-in over-temperature protection
mechanism, the temperature exceeds the set
value to the charging current drop
operation
。
Automatic limit function of rated charging
current.
Flexible System batter y selection: Liquid, Gel,
AGM and Lithium.
Lead-acid batter y charging in four stages:
fast charge, boost charge, equalization
charge, float charge.
PWM charging is programmable to prevent
system failure caused by BMS.
Short-circuit protection is programmable to
prevent output shutdown when opening the
capacitive or inductive loads.
Small size, PID algorithm adopt to control the
voltage output, make the control more stable
and accurate.
The optical control point voltage and
charging voltage can be set.
Perfect EMC & thermal design.
2. Safety instructions and waiver of liability
2.1 Safety Instructions
The following symbols are used throughout
this manual to indicate potentially dangerous
conditions or mark important safety instructions.
Please take care when meeting these symbols.
WARNING: Indicates a potentially
dangerous condition. Use extreme
caution when performing this task.
CAUTION: Indicates a critical procedure
for safe and proper operation of the
controller.
2.2 Liability Exclusion
The manufacturer shall not be liable for damages,
especially
than as intended or as mentioned in this manual
or if the recommendations of the battery
manufacturer are neglected. The manufacturer
shall not be liable if there has been service or
repair carried out by any unauthorized person,
unusual use, wrong installation, or bad system
design.
3. Dimensions（unit: mm）
Page 1 of 10 pages
WARNING:
1) There are no user serviceable parts
inside the controller. Do not disassemble
or attempt to repair the controller.
2) Install the controller in a well-ventilated
place because the heat sink temperature is
very high.
3) Keep children away from batteries and
the charge controller.
on the battery, caused by use other
142
MAX1024-U/MAX2024-U
MAX1024/MAX2024
Unit：mm