3DUpFitters Prusa i3 MK3S Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Involucro 3DUpFitters Prusa i3 MK3S. 3DUpFitters Prusa i3 MK3S 11. Enclosure kit
Anche per 3DUpFitters Prusa i3 MK3S: Manuale di installazione (18 pagine)

Stampa la pagina

There is also a mid-panel corner connector to attach on

the right side. 

Locate the magnetic latches and use the wood screws to

attach them to the latch mounts. Hand tighten and make

sure they're secure, but do not over tighten or they may

strip. The magnetic latch can be later adjusted front-to-

back to make sure the door is ﬂush with the door frame.

Each latch mount is attached via three screws. Two M4

10mm cap heads are used to attach the latch mount to

the side, while a 30mm cap head secures the latch

mount to the door frame.

Attach the latch mount to the front door frame using the

included 30mm M4 screw.

Attach the hinges to the door and door frame using M4

ﬂat head 14mm screws and nuts. There will be some

play in the hole size so that you can adjust the door to

swing freely.

Attach the door knob using a 14mm ﬂat head screw and

nut.

Now that the latches are mounted it is time to connect the strike plates, shown above

to the right of the latch mount. Each plate comes with a squishy adhesive covering the

same size of the plate. Carefully attach the adhesive side to the acrylic at the location

of each latch. Then, adjust the width of the metal strike plate so that it is held on by

the pressure of the two sides of the plate. The adhesive covering will keep the strike

plate from scratching the acrylic.

You can adjust the way the door swings by using the magnetic latch to hold the left

side of the door in place, and then loosing and tightening the screws holding the

hinges on the right. The door should open and close freely. If it doesn't, adjust the

hinges until it does.