Altronics PerformAIRE PRO Installazione

Sfoglia online o scarica il pdf Installazione per Strumenti di misura Altronics PerformAIRE PRO. Altronics PerformAIRE PRO 3.

IMPORTANT: Do not plug cable into computer until after RaceWorks has been installed.

Place the RaceWORKS CDROM in PC's drive.

Software should Auto Install. If not, Load CD Rom and run SETUP.EXE. Follow instructions on the screen to install

RaceWORKS software.

To start RaceWORKS program, click on your START button, go to PROGRAMS, go to RaceWORKS or click on icon

on the Desktop.

Detailed instructions, as well as videos on using software are available by selecting the

"Help" menu icon once program has started.

1) PerformAIRE PRO housing features a standard extension pole mount. If you did not purchase an extension pole

with your system, you can use any typical extension pole found at a local hardware or home store. You can supply

your own mounting method to securely affix pole to trailer or use Altronics Part #ALT-PAPRO-CLAMP.

2) It is recommended to keep antenna on bottom of housing at least 3' from top of trailer.

3) Plug system cable into housing and run cable into trailer. Cable can be ran through trailer access port, door, or

window etc... or use optional bulk head fitting supplied by Altronics Part #ALT-PAPRO-CONNECTOR.

4) Plug cable into USB port on computer.

5) Connect supplied power cable to 12v DC Source (Trailer battery or equivalent), fuse(3 amp fuse).

If a generator is connected to the battery note: Most high end generators provide clean power, if you are unsure we

recommend high voltage transient suppression equipment (noise suppressor) connected in line to avoid "spiking"

transmitter. If you have a 110AC power outlet, an adapter is available to connect to system an eliminate concern for

noisy 12 volt power: Part #ALT-PAPRO-PGPWR

Connect 12 volt power to jack in cable connector.

PerformAIRE PRO's optional remote Display Module Part #ALT-PAPRO-DISPLAY allows for viewing weather

parameters without requiring system to be connected to a computer. Mount Display Module under cabinet or to

trailer wall. Connect 9 pin connector on system cable to connector on back of Display Module housing. Plug 12 volt

power cable into power jack on back of module. You can also connect Display Module to a computer, plug in USB

cable into USB port on back of Display Module and then into USB port of computer.

1411 S. Roselle Rd. Schaumburg, IL 60193

Phone (847) 923-0002 Fax (847) 923-0004

www.AltronicsInc.com

PerformAIRE PRO

Face Direction decal on housing towards

finish line (Parallel to track).

Mark on wind body

Installing RaceWORKS Software

Mounting System to Trailer

INSTALLATION

Top View

Mark on wind body

Track

With mark aligned properly and wind

vane facing as shown will indicate a

Head Wind.

(Do not use non-specified 110 Power adapter it WILL damage unit!)

Remote Display