Altronics Proart A 5030 Istruzioni per l'uso

Sfoglia online o scarica il pdf Istruzioni per l'uso per Amplificatore Altronics Proart A 5030. Altronics Proart A 5030 4. Altronics proart multi-room audio distribution system

Stampa la pagina

Operating Instructions

A 5030

A 5030 Matrix Control Unit

A 5036 Remote Control Wallplate

Overview

Congratulations on purchasing a Proart A 5030 multi-source,

multi-room audio distribution system. This system allows up

to 8 audio program sources (eg tuner, CD, DVD) to be distrib-

uted to six different rooms or zones. It enables the selection

of a desired source and volume setting in each room inde-

pendently of other room settings via infra red

re-transmission. A complete system consists of control wall

plates, input matrix controller, zone amplifier and infra red

(IR) transmitters.

Features

• Remote source and volume selection via wall plate or IR

remote control

• Source selection and volume level display

• Up to 6 speaker zones

• Up to 8 input sources

• Wallplates can be situated up to 50m from controller

• Cat 5 cable and RJ45 connections for easy installation

• Local 3.5mm source input for MP3 players etc.

• Wall plates fit standard electrical wall box

• Easy to install and configure

• Multiple wall plates per zone

• 3 external contact switch outputs

• Priority input

• IR repeaters for external source control (CD, tuner, DVD)

Distributed by Altronic Distributors Pty. Ltd. Perth. Western Australia.

Phone: 1300 780 999 Fax: 1300 790 999

Internet: www.altronics.com.au

www.altronics.com.au

Installation

1. Connect the wallplates using figures 2 & 3 as a guide.

Figure 3 must be used if more than 1 wallplate is used per

zone.

The wall plates will fit into a standard single gang electrical

wall box. Connect the RJ45 plug and cable to either of the

sockets on the rear of the wall plate, with the connecting

cable wired pin 1 – pin 1, pin 2 – pin 2 etc, for all 8 pins.

2. Each wallplate used in the sys-

tem must be assigned a zone num-

ber. To assign a zone number turn

the rotary switch on the rear of the

wall plate (figure 1) to one of the

settings listed below:

Zone 1 – rotary switch set to no. 1

Zone 2 – rotary switch set to no. 2

Zone 3 – rotary switch set to no. 3

Zone 4 – rotary switch set to no. 4

Zone 5 – rotary switch set to no. 5

Zone 7 – rotary switch set to no. 7

Zone 8 – rotary switch set to no. 8

Switch settings 9 and A to F are not used.

If you wish to have multiple wallplates controlling the same

zone, ensure all rotary switches for that zone are set to the

same position.

A 5036

Figure 1: Wall plate

rear detail.

Rotary

Switch

RJ45 RJ45