AluTeam BR 13x-3 Manuale di istruzioni per il montaggio - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Camion AluTeam BR 13x-3. AluTeam BR 13x-3 14. Box kits

Stampa la pagina
Fig. 341
Fig. 345
1
1
MA 350081
Assembly instructions BR 133-3 to 139-3
Fig. 342
Fig. 343
Fig. 344
Fig. 346
Adapter
MA 350147
Molex pin
Adapter
MA 350148
Molex bushing
2
Fig. 351
2
Fig. 352

3.4 Placement and fastening of the roof

•
Push the upper frame nodes laterally into the roof edge. Fix these
hand-tight with 2 flat-head screws M 10x20 MD 100332 each (Fig. 341).
•
•
Lift the roof with a crane or with of a vacuum cross beam over
Lift the roof with a crane or with of a vacuum cross beam over
the transport lugs and carrying straps (
the transport lugs and carrying straps (Fig. 342/343). Set it
down over the structure (Fig. 344).
Danger:
Crane-work involves hazards to life and limb. Never
step under raised loads! Wear a helmet. Lift loads only
vertically and not diagonally! The suspension in the
crane must be above the centre of gravity of the assembly.
•
Keep the roof in the balance while an employee secures the centre
of gravity of the component. Now carefully set the roof down be-
ginning at the front on the front wall (Fig. 344).
•
Centre the roof on the top boom of the front wall. The roof caps
catch on the corner pillars. Align the roof with the wall profiles. Fix
it to the front wall with screws distributed over the entire width.
Attention:
The screws must not tilt and cable and plug not get
squeezed!
•
Lower the roof slowly. The tips of the frame nodes pointing down
should be centred on the frame pillars. Fix the nodes in the pillars
hand-tight with flat-head screws M 10 MD 100329 (Fig. 344/345).
•
Screw the side wall/front wall to the roof with the module assem-
bly screws MD 100224, until the required torque 10 Nm ± 1 Nm is
reached (Fig. 346).

3.5 Connection of the attached electrics

•
The cable connections of the kits BR13x-3 can be mounted very
simply as follows:
For the cabling of the navigation lights and the third stop
•
light , just connect
tion (to the right) into the right frame pillar (Fig. 351).
Attention:
The cables and connectors must not be crushed.
•
Now connect the different lights and the reversing camera:
•
For the cabling of the LED strips
sensor), just connect
tion downward into the left frame pillar (Fig. 352).
Remark: The illustration indicates a cabling with LED strips on the
right and left.
Status 03/2022
Former instructions lose their validity.
1.
2.
the plugs and slide
the plug connec-
with
motion detector (infrared
1.
2.
the plugs and slide
the plug connec-
8 / 14