ARTROMOT K4 Manuale di servizio - Pagina 16

Sfoglia online o scarica il pdf Manuale di servizio per Attrezzature per il fitness ARTROMOT K4. ARTROMOT K4 18.

Stampa la pagina

10. How to perform repairs

10.1 How to remove the housing cover (Pos. 3.60).
Move the ARTROMOT®-K4 in a position of approximately
110 degrees.
Turn the power OFF at the ARTROMOT®-K4 and remove
the power cord.
Hit the 4 pins of the split rivet (Pos. 3.24) inwards.
Remove the 2 covering plates (Pos. 3.22)
Loosen the 2 countersunk screws (Pos. 3.50) and remove
the casing.
Remove the 4 pins of the split rivet, which are inside the
casing.
If you have exchanged any of the printed circuit boards
including the knee electronics and the hand held
programming unit or any parts of the drive technology,
you have to perform a calibration. See chapter 9.1.
Finally, a safety and function test has to be performed.
10.2 How to exchange the motor control (Pos. 1.35).
ATTENTION!
When you assembling with electronic parts make
sure to use ESD (Electro Static Discharge) equipment.
Remove the housing cover, see chapter 10.1.
Pull out the connectors of the motor control.
Loosen the four screws.
Exchange the defective motor control and fix it with the
screws.
Put back in the connectors in the same position.
3-pin connector 2-pin connector
Rebuild the housing cover.
A calibration has to be performed.
Finally, a safety and function test has to be performed .
10.3 How to exchange the power supply electronics
(Pos. 1.41).
ATTENTION!

When you assembling with electronic parts make sure

to use ESD (Electro Static Discharge) equipment.

Remove the housing cover, see chapter 10.1.
Pull out the connectors of the power supply electronics.
Loosen the four screws.
Exchange the defective electronics and fix it with the
screws.
Put back in the connectors in the same position.
Rebuild the housing cover.
A calibration has to be performed.
Finally, a safety and function test has to be performed .
10.4 Repairs of the drive unit.
ATTENTION!
Only authorized and certified staff may perform repairs
and maintenance at the drive unit otherwise the
manufacturer´s warranty and liability will be invalidated.
16