- ページ 14

屋外暖炉 AMD DIrect FPB-25SFPSSF18TPSI-PのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。AMD DIrect FPB-25SFPSSF18TPSI-P 20 ページ。 Square flat pan fire pits with thermocouple piloted safety ignition (tpsi) & pro brass snowflake burner

ページを印刷する

1. The fire pit should be inspected and cleaned before initial use, at least annually, by a qualified field service person.

2. Any component that is found faulty must be replaced with an approved component.

3. Any tampering or modifying with the fire pit is dangerous and voids all warranties.

4. During winter months in cold climates and various seasons of operation the fire pit may be affected by weather

conditions. It is recommended to use a ventilated cover over top of your fire pit to protect it from humid/rainy weather

conditions when not in use. Heavy rains/downpours could affect the fire pit operation if not covered; if this occurs

ensure you allow the fire pit time to dry out before attempting to operate. NOTE: If a combustible type cover is used

over the fire pit when not in use be sure to remove it before operation to prevent a severe safety hazard.

5. Over time stainless steel parts can discolor when heated, usually a golden or brown hue. This discoloration is normal

and does not affect the performance of the appliance.

Brass Burner Maintenance Information:

•

Dust in injector - Use compressed air from aerosol can or compressor.

•

Check for bug nests or stubborn debris - replacement where necessary.

Note: Always use safety equipment including but not limited to SAFETY glasses or goggles when using

compressed air and consider a disposable mask for particulate.

Symptom

Remedy

Fire pit won't light

1. Bleed gas line.

2. Ensure all gas supply lines are turned ON.

3. Ensure there is not too much media over top of burner; it can inhibit gas from flowing.

4. Check gas pressure.

Low flame

1. Ensure the base media is at least 1-inch in diameter and top media is no more than 1-inch over

2. Ensure all shut-off valves and key valve is fully open. See page 9; Fig. 7

3. Check gas pressure.

Water in my fire pit

1. Excess dust/sand material from media may be blocking the weep holes to relieve water.

2. Remove all media and unplug weep holes. Clean or install new media free of dust and dirt.

3. Ensure fire pit enclosure has proper drainage for water and proper ventilation to dry out.

FOR TECHNICAL SERVICE, CALL:

Manual changes often occur, ensure to check the Firegear Outdoor

Drop In & Flat Pan Fire Pits with Snowflake Burner and (TPSI) Ignition

FIRE PIT MAINTENANCE

TROUBLE SHOOTING

top of burner and do not cover injectors.

Huntington Beach, CA 92647

Web Site: www.firegearoutdoors.com

website for any recent updates and warranty information.

(800) 966-8126

AMD Direct, Inc

17322 Gothard St

REV. A

Page 14