- ページ 2

カーアラーム AME MM-1のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。AME MM-1 6 ページ。
AME MM-1 にも：ユーザーマニュアル (15 ページ), インストレーション・マニュアル (14 ページ)

ページを印刷する

Function programming.

1. Follow through with transmitter programming and turn the ignition back on (before the double siren beep in the

above item 3!).

2. Press button 1 on the transmitter 12 times. The alarm system will provide an audible confirmation on each

pressing the button. When you are pressing the button the 12th time the siren will emit two long beeps

followed by two short beeps.

3. Press buttons 1 and 2 together to enter the Installer Software Switch Table.

4. Enter the number of the function that you want to adjust by pressing button one on the transmitter to increase

the number of function or by pressing button 2 to reduce the number of function.

5. Each time the transmitter button is pressed; the siren will beep to indicate the switch that is selected. The

following siren beep sequence will be used: Switch 1 = One short beep, Switch 2 = Two short beeps, ...

Switch 5 = One long beep, Switch 6 = One long beep and one short beep, ... and so on.

6. Press both buttons 1 and 2 to toggle the status of the dual state functions from option 1 to option 2 and from

option 2 to option 1. If the Software switch includes more than two states, follow the instruction within a

respective line of the table below.

7. If option 1 is selected, the LED will be on. If option 2 is selected, the LED will be off.

8. Turn off the ignition and wait 15 seconds. The system will give a double beep to confirm it has exited software

switch adjustment.

Installer Software Switches

Software

Function

Switch

Dome Light Cars

Door (+/ ) Input Polarity

CDL Locking Time

4***

Twenty Second Locking

Shock Sensor Main Trigger Sensitivity

1 = Minimum Sensitivity

10 = Maximum Sensitivity

LED will flash according to the current setting when

the switch is selected.

Press buttons 1 and 2 together to enter the setting.

When required sensitivity is set press buttons 1 and 2

once again to confirm and exit the setting.

Shock Sensor will be in a test mode when this

switch is selected to allow testing sensitivity.

Shock Sensor Pre Warn Trigger Sensitivity

1 = Minimum Sensitivity

10 = Maximum Sensitivity

LED will flash according to the current setting when

the switch is selected.

Press buttons 1 and 2 together to enter the setting.

When required sensitivity is set press buttons 1 and 2

once again to confirm and exit the setting.

Shock Sensor will be in a test mode when this

switch is selected to allow testing sensitivity.

7**

Trunk ( )/Pre Warn( ) Input

*NOTE:

WARNING: The Shock Sensor can be adjusted to operate as either one stage or two stage Sensor. To have

one stage Shock Sensor set the same level of sensitivity for both Pre Warn and Main Trigger; for getting two

stage Sensor set the Pre Warn Trigger sensitivity at least one level Higher than Main Trigger sensitivity.

Default Setting

Option 1

Option 2

OFF

Negative

Positive

Negative

0.8s

OFF

Down

(A single beep

(A double beep

will confirm

each pressing)

Down

(A single beep

(A double beep

will confirm

each pressing)

Trunk ( )

Pre Warn

Installation manual

AME MM 1 Car Alarm System

СХЕМА ПОДКЛЮЧЕНИЙ

Подключение дополнительного двухуровневого датчика

Инструкция по установке

AME MM 1 Автомобильная охранная система