- ページ 4

メディア・コンバーター AerobTec Telemetry ConverterのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AerobTec Telemetry Converter 8 ページ。 Futaba / frsky telemetry

The power supply of the Telemetry Converter must be done only from the Altis Device (connected to the

COM connector of the Telemetry Converter) through the Molex/JR cable. The power supply of the receiver

does not function when connected only through Telemetry Converter – the receiver needs a separate

power supply. The signal polarity must be observed as shown in Table 1.

Telemetry Converter is connected to the COM connector of the Altis Device with a pair of JR/Molex cables.

In order to activate the Futaba/FrSky telmetry, it is necessery to set the Futaba/FrSky telemetry in the Altis

Device through the Altis Fligh Manager software as shown in the Fig. 2.

Fig. 2: Example setting in Altis Flight Manager

(Altis v4 -> COM A)

The Telemetry Converter communicates with the FrSky device through a FrSky Smart Port (S.Port)

protocol. In the case of FrSky telemetry, only the receiver may be connected to the RX connector.

First of all, it is necessary to find the appropriate connector on the receiver (the one with a Smart-Port

marking). In order to connect the Telemetry Converter with the receiver, a JR / Molex cable must be used.

AerobTec Telemetry Converter User Manual