- ページ 2

おもちゃ AIR core Cathy II P-51 MustangのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AIR core Cathy II P-51 Mustang 2 ページ。

ページを印刷する

OPTIONAL INSTALLATION OF

THE LANDING GEAR

RANGE CHECK

With the transmitter powered and the battery plugged into

the AirCore Module, walk 50' [15m] from the aircraft and

check the control functions for proper and smooth operation.

FLYING THE AIRCORE AIRPLANES

Take off (or hand launch) directly into the wind.

Hand launch with throttle set at ¾ power, wings level and

with a slight toss (it is not necessary to aggressively throw

this model to hand launch it).

Once in the air, gain altitude to allow yourself sufﬁ cient

reaction time to make a correction during ﬂ ight.

Once you're comfortable, adjust the aileron, elevator

and rudder trims one click at a time so that the AirCore

P-51 Mustang ﬂ ies straight and level with the control

sticks centered.

You will quickly notice that the P-51 Mustang has the feel

of a larger R/C airplane. The airplane requires only small

amounts of control stick movement to ﬂ y smoothly.

It's recommended that you attempt to land before the motor

loses power and doesn't have enough voltage to maintain

altitude. If you have a timer on your transmitter, set it for

4-minutes for the ﬁ rst couple of ﬂ ights. Then, gradually

increase the ﬂ ight time to ﬁ t your ﬂ ying style. Allow at

least an extra 1-minute of ﬂ ight time to allow for a second

attempt at landing.

flyzoneplanes.com

If possible, always land directly into the wind.

Gradually reduce power when you are close to the landing

spot. When close to the ground and about to touch down,

pull the elevator stick back slightly to raise the nose of the

model and slow the landing speed to "ﬂ air" for landing.

Unplug and remove the battery from the model and

switch off the transmitter. Allow the motor to cool

between flights.

REPAIRS

Repairs can be made to the AirCore P-51 Mustang by using

the following items:

● Formula '560' Canopy Glue (highly recommended)

(PAAR3300)

● Thick Foam Safe CA (for quick ﬁ eld repairs)

(GPMR6072)

● Foam safe CA accelerator (GPMR6035)

● Two sets of needle nose pliers or hemostats

(HCAR0625)

● Hobby Knife (#11 blade) (RMXR6900)

● Electric Flyer Hinge Tape (DUBQ0916)

REPLACEMENT PARTS

To order replacement parts for the AirCore P-51

Mustang Cathy II, use the order numbers in the list

below. Replacement parts are available only as listed.

Replacement parts are not available from Product Support,

but can be purchased from hobby shops or mail order/

Internet order ﬁ rms. If you need assistance locating a

dealer to purchase parts from, contact:

Product Support

E-mail: [email protected]

Stock No.

Description

● FLZA6404 AirCore P-51 Cathy II Spinner

● FLZA6415 AirCore P-51 Cathy II Fuselage

● FLZA6419 AirCore P-51 Cathy II Wing

● FLZA6423 AirCore P-51 Cathy II Hatch

● FLZA6426 AirCore P-51 Landing Gear

● FLZA6427 AirCore Airframe Push Rod Set

● FLZA6428 AirCore Hardware Set

FLZA3904

Phone: 217-398-0007

Fax: 217-398-7721

™