- ページ 10

グリル Ameritrax 182269002022のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Ameritrax 182269002022 13 ページ。 Portable barbecue & stove

REGULATOR VALVE & LP GAS BOTTLE INSTALLATION

WARNING

- Prior to assembly and leak test, inspect Regulator Valve and LP Gas bottle for

damage, dirt or debris accumulation. Clean out if present. Replace if damaged.

WARNING

- NEVER depress dial control on the Regulator Valve during installation.

CAUTION

- Make sure Regulator Valve is in the OFF position prior to installation of LP Gas bottle.

Step 1.

REGULATOR VALVE TO LP GAS TANK INSTALLATION.

Remove cap from end of LP Gas bottle.

While holding Regulator Valve in one hand, and the

LP Gas bottle in the other, insert threaded end of

the LP Gas bottle into the Regulator Valve. Apply

gentle pressure while inserting threaded end of LP

Gas bottle and turn clockwise into the Regulator Valve.

Hand tighten only until a snug fit is achieved.

Step 2.

REGULATOR VALVE TO BURNER BAR INSTALLATION.

With one hand, firmly grasp installed Burner Bar.

With other hand, firmly grasp LP Gas bottle with

Regulator Valve dial control pointed downward.

Line up the notch in Regulator Valve with the

detent located inside the nozzle end of the Burner Bar

and insert Regulator Valve into Burner Bar nozzle.

When Regulator Valve has completely engaged the

Burner Bar, gently rotate the Regulator Valve until

LP GAS bottle rests securely on level surface.

Regulator Valve will lock into place.

ATTENTION

- Notch in Regulator Valve MUST engage detent in the nozzle end of the

Burner Bar.

WARNING

- NEVER hang LP Gas bottle off the edge of a table surface. Rest the base of the LP

Gas Bottle at an angle to the surface on which the Grill is resting.

WARNING

- FOR YOUR SAFETY. We recommend the use of one pound LP Gas Tank bottles.

NEVER hook-up gas line hoses or LP Gas tanks larger then one pound.

DANGER

NEVER use Natural Gas with this Grill. Grill is designed for Propane Gas only

WARNING

- NEVER use tools to tighten Gas Bottle to Regulator Valve. Over-tightening will

cause damage to threads on Regulator Valve, which may result in gas leakage.