- ページ 4

コントローラー AMERITRON SDC-103のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AMERITRON SDC-103 13 ページ。 Automatic screwdriver antenna controller for icom radios

SDC-103 Automatic Screwdriver Controller (ICOM)

You will need to connect wires to each of these four wires, so that they will

reach your screwdriver antenna. Use quality insulated wire for these extensions.

The motor control wires should be no smaller than 18 AWG. the sensor wires

should be no smaller than 24 AWG.

Installation (B)

Controllers that have the 4 pin Molex plug.

1. The red wire needs to be fused and connected to the

vehicle's +12 VDC supply. The size of the fuse depends

upon the current requirement of the antenna motor.

Typically a 5 Amp slow-blow fuse will work. Some

installations may require additional wire. Use 16 AWG

wire to add additional length.

2. The black wire needs to be connected to the vehicle

(station) ground.

If the supplied red and black wires are not long enough,

Use 16 AWG wire to add additional length.

3. Connect the 4 pin Molex to the antenna.

Antennas that do not have a 4 pin plug. The plug can be cut

off. Use the chart below for wire color and its function.

CONTROL CABLE

RED

BLACK

GREEN

WHITE

Instruction Manual

motor control

MOTOR WIRE

SENSOR