- ページ 10
屋外暖炉 Astria ValiantOD36P2のPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Astria ValiantOD36P2 20 ページ。 Outdoor vent-free firebox
7. Install and properly test gas log heater. Follow installation instruc-
tions included with vent-free gas log heater that is being installed.
IMPORTANT: When finishing your firebox, combustible materials
such as wall board, gypsum board, sheet rock, drywall, plywood,
etc. may be butted up next to sides and top of firebox. Combustible
materials should never overlap firebox front facing.
WARNING: Do not allow any combustible materials
to overlap firebox front facing.
IMPORTANT: Noncombustible materials such as brick, tile, etc. may
overlap front facing, but should never cover any necessary openings
like louvered slots.
Nails or Wood
Screws
Nailing
Flanges
Nails or
Wood
Screws
Nailing
Flanges
Indoor/Outdoor Firebox
Figure 8 - Attaching Firebox to Wall Studs
10
INSTALLATION Continued
Indoor Firebox
WARNING: Do not allow noncombustible materials
to cover any necessary openings like louvered slots.
WARNING: Use only noncombustible mortar or
adhesives when overlapping the front facing with
noncombustible facing material.
INSTALLING FIREBOX USING OPTIONAL ACCESSORY MANTELS
WARNING: A qualified service person must install
firebox. Follow all local codes.
This firebox may be installed using a cabinet mantel accessory against
a wall in your home. Firebox and cabinet mantel can be installed di-
rectly on floor. A trim kit is included with mantel accessories. Follow
instructions with mantel for installation.
INSTALLING GAS LINE
NOTICE: A qualified service person must connect heater
to gas supply. Follow all local codes.
IMPORTANT: See Connecting to Gas Supply in your log set owner's
manual for details on gas hookup.
You may run gas line from either side or back of firebox (see Figure
9, page 11). Decide which side you want to run gas line from.
Note: This is one option for installing shutoff valve. Check local codes
for equipment shutoff valve location requirements.
Locate recessed knockout in one firebrick liner (see Figures 9 and 10,
page 11). Firmly tap center of knockout with a chisel until it is released.
Carefully chisel rough edges of hole you have made to smooth edges.
This hole will line up with hole in outer casing.
CAUTION: Do not use excessive force to remove the
knockout. Too much force may damage the firebrick
concrete insert.
Astria.US.com
126773-01B