ページを印刷する
GAGING INSTRUCTIONS
Gaging the tool requires the M22520/3-01 Gage Pin
Assembly, Astro part # 615716.
1. Set the tool to selector setting # 4.
2. Close the handles to the fully closed position.
3. Holding the tool closed, insert the GO pin into the
indenter opening as shown, see figure # 1 The gage must
pass freely between the indenter tips.
4. Holding the tool closed, insert the NO GO pin into
the indenter opening. The gage pin must NOT go
between the indenter tips.
G O
DO NOT CRIMP GAGE.
TOOL DAMAGE WILL RESULT.
Astro manufactures the ATK6002 gaging kit with
gage pin assemblies for each selector setting. Contact
the factory for price and availability.
ASTRO TOOL CORP. MANUFACTURERS OF INSERTION, REMOVAL,
CRIMP TOOLS AND CONNECTOR SERVICE KITS
ASTRO TOOL CORPORATION • 21615 S.W. T-V HWY. • BEAVERTON OREGON 97003
Figure # 1
CAUTION:
503-642-9853 • FAX 503-591-7766
GAGING INFORMATION
( Dimensions in Inches )
SELECTOR
SETTING
NUMBER
1
2
3
4
5
6
7
8
TOOL SERVICE
Astro Tool's 615708 Crimp Tool is designed for
long, reliable service. If the tool becomes inoperative or
does not gage properly, it is suggested that you contact
our Customer Service Department for a Return Goods
Authorization number and return the tool to our factory.
Upon receipt of the tool, Astro will inspect and
overhaul each tool to put the tool back into acceptable
and efficient operating condition. Worn parts will be
replaced or repaired. Please note that Astro's Quality
Control system is traceable to The National Institute of
Standards and Technology (N.I.S.T.).
Service charges for tools not under warranty will be
advised upon request.
Parts that Astro deems to have been damaged due to
neglect, misuse or accident; and parts that have been
altered or repaired by persons other than Astro Tool
Corp. employees will be replaced subject to additional
charge for such parts.
2
GO
NO GO
SIZE
SIZE
± .0001
±.0001
.0280
.0330
.0320
.0370
.0360
.0410
.0390
.0440
.0450
.0500
.0520
.0570
.0590
.0640
.0680
.0730
5-21-15 TI708-93-3