- ページ 10

ネットワーク・ハードウェア Amphenol Telect 009-7001-0104BのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Amphenol Telect 009-7001-0104B 15 ページ。 High-current demarcation panel

ページを印刷する

13. Clean the terminals with a nonabrasive,

nonmetallic pad.

14. If required, lightly coat antioxidant on lugs

and input terminals and then connect lugs

to input terminals on back of panel. Tighten

lugs to 36 in/lb. (4 N•m).

15. Before installing breakers and output wiring,

turn power on to verify input power and

indicators:

Verify input voltage and polarity

•

Whenever power is supplied, expect the

•

corresponding PWR ON LED to light

16. For output wiring, repeat steps 8 through 12

for BATT and RTN outputs (crimp output wires

to lugs, clean output terminals and attach lugs

to output terminals). Heat shrink the insulation

onto the lug barrels.

17. Record the circuit assignments on the pull-out

designation card below the alarm display.

18. Attach the plastic covers over all output terminals.

CAUTION! Amphenol Network Solutions recommends

that the individual circuit load not exceed 80% of fuse

capacity (for example, 100A fuse x .80 = 80

max. load).

19. Make sure output devices — devices fed from the

outputs of this demarcation panel — are disabled.

20. With input power on, firmly install each fuse in

panel, as shown in Fig. 9.

Fuses are designed so that the fuses can be

installed in one way only.

21. Check voltage and polarity at output terminals

and equipment ends.

22. Test the alarm card:

High-Current

Demarcation Panel

Fig. 7: Input/Output lug connections

Fig. 8: Power and alarm LEDs on front panel

Fig. 9: Installing fuses

Amphenol Network Solutions

509.926.6000 — amphenol-ns.com.com