- ページ 7
エクステンダー Amplitec C10G-CPのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amplitec C10G-CP 13 ページ。 Wide band mini booster
2
1. DC+5V Power supply voltage is +5V
2. BS Output port, to be connected with service antenna
3. Grounding, equipment can be grounded by screwing
4. MS Input port, to be connected with donor antenna
5. CDMA Alarm Indicator
Green Means ALC doesn't work
Orange Means ALC starts control in 5~10dB
Red Means ALC starts control in 15~20dB。
6. PCS Alarm Indicator
Green Means ALC doesn't work
Orange Means ALC starts control in 5~10dB
Red Means ALC starts control in 15~20dB。
7. PCS ATT :
To adjust Uplink or Downlink Gain. ( arrow pointed to 5 means the gain will be
reduced 5dB; arrow pointed to 10 means the gain will be reduced 10db ; arrow
pointed to
15 means the gain will be reduced 15dB )
8. Celluar ATT:
To adjust Uplink or Downlink Gain. ( arrow pointed to 5 means the gain will be
reduced 5dB; arrow pointed to 10 means the gain will be reduced 10dB ; arrow
pointed to 15 means the gain will be reduced 15dB )
Installation Guide
Before your install
Make sure have sufficient cable length between proposed donor to server antenna
location and booster connector.
Make sure the position you install the booster is near to one existing electrical outlet,
and well ventilated, away from excessive heat, moisture, direct sunlight.
Installation overview
Install your donor antenna on the roof where there is the strongest signal.
Mount your signal booster, connect cables to the signal booster from the outside
antenna and inside antenna at the designated ports, and connect the booster to AC
power supply.
Install the indoor antenna where you want to improve signals.
Amplify your world
7 / 13