- ページ 14

温度計 Amprobe RTD-10のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Amprobe RTD-10 19 ページ。 Rtd

Amprobe RTD-10 ユーザーマニュアル
"TYPE"(Pt385/Pt3926/Pt3916) Second display Input
RTD Probe select
The Pt385/Pt3926 key switches the T2 input to select
the Pt385, Pt3926 or Pt3916 RTD probe as input, when
second display input selected T2. When the thermometer
is turned on, it is set to the RTD selected that was in use
when the thermometer was last turned off.
"Hi/Lo LIMITS" Mode (only Main display)
Press "Hi/Lo LIMITS" key to enter the Hi/Lo Limits
comparative mode. When the input temperature value
exceeds the Hi or Lo Limits value, the beeper emits a
continuous or pulsed tone. Press "Hi/Lo LIMITS" key
again to exit the Hi/Lo Limits mode.

Wireless Mode (RTD-10W Only)

Press the " " key for more than two seconds to start
wireless function. Press the " " key again for another
two seconds to stop wireless function. The wireless mode
will shut down if there is no wireless signal for two
minutes.
To SET CH/ID to 00,00, press the "Hi/Lo LIMITS" key and
"
" power key for more than 6 seconds with the meter
powered down. The meter will set channel and ID to
00,00 status. The second display will show 00, which
means that the channel and ID has been set to 00.
To check the channel and ID of the meter
When the meter is off, press "°C/°F" key and "
" for 5
seconds, LCD's main display will show channel number,
the second display will show ID number.
8