- ページ 2

ヘッドセット Amron AMCOM III 2830A-13のPDF プログラミング手順をオンラインで閲覧またはダウンロードできます。Amron AMCOM III 2830A-13 3 ページ。 Base station & remote headset

BASE STATION & REMOTE HEADSET PROGRAMMING

When programming a replacement headset, the base-station needs to be cleared before a "Remote" unit can be linked to it.

Follow the steps below to clear the base-station. All remote units should be "OFF" before starting this process.

1. Remove base-station from the Amron Communicator lid. Channel selection buttons "1" and "2" are located on the rear side

of base-station.

2. Turn Amron Communicator Power "ON". Located on the bottom right of the HUB, turn the base-station dial switch "ON".

The Green LED, located on the left side of base-station next to power jack, will turn on.

3. Press the base-station #1 programming button until the Red LED starts flashing.

4. Press the base-station #1 programming button 7 times. The Red LED will begin rapid flashing, and then will go out. At this

point, the base-station has no remotes programmed to channel 1.

5. Press the base-station #2 programming button until the Red LED starts flashing.

6. Press the base-station #2 programming button 7 times. The Red LED will begin rapid flashing, and then will go out. At this

point, the base-station has no remotes programmed to channel 2.

7. The headsets channels are now cleared of programing to the base-station.

Follow the "Base-Station Programming Instructions" to link headsets.

28B Wireless System Programming

CLEARING THE BASE-STATION

REV 2.0