- ページ 4

コントロールユニット AMS QG001003のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。AMS QG001003 9 ページ。

ページを印刷する
AMS QG001003 クイック・スタート・マニュアル
2

Software Installation

1.
Plug the ams flash drive into an unused USB port
2.
Double-click the Setup.exe file on the flash drive, or click Start > Run and type E:setup.exe and
press Enter. IMPORTANT: Use the appropriate drive letter in the above command to install the
software. Flash Drive will commonly be assigned the next available drive letter for example C:
hard drive, D: CD-ROM, E: flash drive
3.
The Setup Wizard will open and guide you through the installation of the TMD2636 host
software, (Figure 2 through Figure 8)
4.
The EVM Controller board requires the installation of FTDI CDM drivers. If these drivers are not
installed on your machine, this setup will automatically launch the installer for the FTDI drivers.
5.
At the end of the installation, click Finish to exit the setup.
Figure 2:
Welcome Screen
Quick Start Guide • PUBLIC
QG001003 • v1-00 • 2021-Jan-18
Document Feedback
Figure 3:
Liability Disclaimer
TMD2636 ● TMD2636 EVM
Software Installation
│ 4
9