- ページ 6

洗濯機 Electrolux EW 1042 SのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux EW 1042 S 22 ページ。

All transit bolts and packing must be

removed before using the appliance.

You are advised to keep all transit devices so

that they can be refitted if the machine ever has

to be transported again.

1. Using a spanner, unscrew and remove the

rear right-hand bolt.

2. Lay the machine on its back, taking care not

to squash the hoses. This can be avoided by

placing one of the corner packing pieces

between the machine and the floor.

3. Remove the polystyrene block from the

underside of the machine.

4. Release the two plastic bags by removing the

adhesive strip.

Carefully remove the right-hand bag (1) then

the left-hand bag (2) by pulling them towards

the centre of the machine.

5. Set the machine upright and remove the two

remaining bolts from the back.

6. Pull out the three plastic pegs from the holes

into which the bolts were fitted.

7. Plug the open holes with the plugs which you

will find on the back of the machine.

Install the machine on a flat hard floor.

Make sure that air circulation around the

machine is not impeded by carpets, rugs etc.

Check that the machine does not touch the wall

or other kitchen units.

Carefully level by screwing the adjustable feet in

or out. Never place cardboard, wood or similar

materials under the machine to compensate for

any unevenness in the floor.

After having levelled the machine, tighten the

lock nuts.

INSTALLATION

P0255

P0234

P0256

P0254

P0233

P0020

P0509