- ページ 4
ドア開閉システム Andersen SmoothControl+ Left Hand Hydraulic CloserのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Andersen SmoothControl+ Left Hand Hydraulic Closer 4 ページ。 Replacement for andersen 1-1/2” fullview storm doors
REMOVE HYDRAULIC
1
CLOSER AND INSTALL
REPLACEMENT PART
FOR FIXED LAMINATED
(continued)
e
1.
Using a Phillips screwdriver, remove the one additional unpainted
screw from the other end of the hydraulic closer unit and properly
dispose of the screw.
2.
Lift up the hydraulic closer unit straight out of door frame and properly
dispose of the hydraulic closer.
g
1.
Pull the closer arm away from door frame
towards the interior until it clears the
hydraulic closer hole, then reinstall the
locking pin into the top of the hydraulic
closer unit.
h
LOCKING
PIN
1.
Partially close the door and pull down
slightly on the closer arm to align the bolt
under the rain cap. Reconnect the hydraulic
closer arm to the rain cap damper assembly
using the provided hex wrench.
Tools recommended:
Hex Wrench
(provided)
Screwdrivers
!
!
f
5/8"
5/8"
5/8"
5/8"
1 1/2"
1.
Install the new replacement hydraulic closer unit into the top of the
1 1/2"
door, being careful to position it so all three screw holes align with
screw holes in door frame.
2.
Install three unpainted flat head screws into the top of the hydraulic
closer unit. The screws are provided in the clear hardware bag.
1 1/2"
i
1.
Open door fully and remove the locking
pin from the top of the hydraulic closer
unit.
4
CLEAR HARDWARE BAG
Unpainted Flat
Head Screws
!
!
1/2"
2"
1 1/2"
LOCKING
PIN
(Qty 3)
1
1/2"
1
2"