- ページ 9

計測機器 ANDILOG CENTOR FIRST IIのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ANDILOG CENTOR FIRST II 12 ページ。

Battery indicator: varies between 0% and 100% to indicate the battery life. When the battery is new,

the autonomy is about 15 hours in continuous use. When the battery percentage reaches 0% the force

gauge turns off.

: indicates the capacity of the sensor installed in the instrument.

Capacity display

Bar graph: The bar graph shows the operator how much force is being applied relative to the

maximum capacity of the load cell. When a compression force is applied, the bar graph fills up. When

a tensile force is applied, the bar graph fills in downwards.

Measurement display :

A force applied in tension will be preceded by the symbol ▼

A force applied in compression will be preceded by the symbol ▲

Indicates the direction of the

measurement

(tension

compression). Force measured

in instantaneous

Maximum traction from the

tare

Maximum compression from

tare

3.3.1. Do the Zero

The display order can be changed by pressing the

During tests, it is often necessary to reset the display to zero (e.g. to tare an accessory). Press the

3.3.2. Change the unit of measurement

green 0 key. The display then shows 0.

You can choose from the following units: N, kg, lb and daN. To change the unit display, press the U

key. Each successive press will select the next unit until you return to the starting unit. The Centor

First II will automatically convert the display and capacity to the new chosen unit and display the

corresponding unit symbol.

- 9 -

User's manual

CENTOR FIRST II