- ページ 6

バリカン Andis UltraEdge AGC2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Andis UltraEdge AGC2 20 ページ。 Andis company model agc2 hair clippers - use and care guide
Andis UltraEdge AGC2 にも：ユーザーマニュアル (2 ページ), 仕様 (2 ページ), 仕様 (2 ページ), パーツリスト (1 ページ), 使用とケア (2 ページ)

ページを印刷する

then place a drop of clipper oil where the upper and lower blades meet and also

in the guide slot of the tension spring (Diagram H). Now slide the upper blade

to the opposite side of the lower blade and repeat this process. After completing

this procedure, slide the upper blade, centering it over the lower blade. Handle

or store your Andis Clipper with the blades down so excess oil will not run into

the clipper case.

CHANGING tHE bLAdE drIvE ASSEmbLy

If your clipper blades no longer cut properly (be sure to try more than one

blade, since the blade currently being used may be dull), it could be that your

blade drive assembly needs replacement.

to change the blade drive assembly:

1. Remove blade set (Diagram I).

2. Remove drive cap (Diagram J).

3. Remove blade drive mounting screws (Diagram K).

4. NotE: Before removing blade drive assembly, note the way it is positioned

(this will help you in reassembly). Remove blade drive assembly (Diagram L).

5. Drive bearing should be at its lowest position, if not, move it with your finger

to lowest position (Diagrams M & N).

6. Put on new drive assembly, align screw holes and press down (Diagram L).

7. Reassemble blade drive by mounting screws (Diagram K).

8. Replace drive cap (Diagram J).

9. Replace blade (Diagram O).

fACtory rEpAIr SErvICE

When the blades of your Andis clipper become dull after repeated use, it is

advised to purchase a new set of blades available through your Andis supplier

or through an Andis Authorized Service Station. Some blade sets can be

resharpened–contact Andis Company for information on resharpening. To find

an Andis Authorized Service Station near you log on to www.andis.com or

contact our customer service department: 1-800-558-9441 (U.S.) or

1-800-335-4093 (Canada).

Caution: Never handle your Andis clipper while you are operating a water faucet,

and never hold your clipper under a water faucet or in water. There is danger of

electrical shock and damage to your clipper. Andis Company will not be

responsible in case of injury due to this carelessness.