- ページ 14
サブウーファー andover Model-OneのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。andover Model-One 19 ページ。 Modular stand system
andover Model-One にも： 製品マニュアル (14 ページ), 製品マニュアル (8 ページ)
ページを印刷する
MODEL ONE Turntable Setup Guide (Continued)
Cartridge
Stylus Guard
STEP 4 - Balance the Tonearm
•
Install the counterweight by pushing it carefully onto the rear of the tonearm until the
threaded section clicks lightly into place.
•
Remove the stylus guard from the cartridge.
•
With the tonearm lift lever in the lowered position, move the tonearm from its rest to
a position where it can move freely.
•
Rotate the counterweight until the tonearm tube balances such that it floats level.
•
Once the tonearm is correctly balanced, return it to the tonearm rest position.
STEP 5 - Set the Tracking Force
•
Use one hand to hold the counterweight in position to keep it from moving.
•
Use your other hand to gently revolve the downforce scale ring until the zero (0mg) is
vertical at the 12 o'clock position.
•
Next, rotate the counterweight and downforce scale ring together as one, counter-
clockwise (as seen from the front) to adjust the downforce according to the cartridge
manufacturer's recommendations using the numbers on the downforce scale ring.
•
Set the counterweight scale to 18nM (1.8g) for the supplied Ortofon 2M Silver.
STEP 6 - Set the Anti Skate force
•
Carefully hang the anti-skate weight
over the wire loop and attach the string
to the appropriate groove on the anti-skating stub.
•
For the supplied 2M silver, set the string in the middle groove (Groove 2, shown in
example above). Important note: If you should change to a different cartridge in the
future, refer to the recommendations of the new cartridge for tracking force and anti-
skate setting.
Anti-Skate Wire Loop
Tonearm
Tonearm Rest
Page 14
Anti-Skating Stub (white line)
Tonearm Lift Lever (in high position)
-Downforce
+Downforce
Groove 1
Groove 2
Groove 3
Counterweight
Back of counterweight
Downforce scale ring
Anti-Skate Weight
Anti-Skate Wire Loop