- ページ 6

掃除機 Electrolux AfueraのPDF プランニング＆インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Electrolux Afuera 10 ページ。 Central cleaning system
Electrolux Afuera にも：オーナーズマニュアル (6 ページ)

ページを印刷する

Be sure to hold wire perfectly horizontal so that

both interior and exterior holes line up with one

another. Check for inner wall obstructions by

bending short length of coat hanger wire at a

right angle and twirling this right angle piece

inside the wall.

Drill a 2 1/4" (5.7cm) hole horizontally through

both sides of wall.

Make the hole in the exterior wall surface into

the same shape opening as described previ-

ously in

STEP 1 - (Installing Inlet Valves) (Fig. 4).

From inside closet, cut 2-1/4" (5.7cm) hole

through floor, either directly below opening in

wall or at convenient spot. (Caution: - Make

pilot hole as in STEP 1 previously.) Run low-

voltage wire through 2-1/4" (5.7cm) hole in

floor, and through wall to exterior of closet.

Pass low-voltage wire through the wire guide

hole of the inner wall closet assembly (Fig.

15) and tape low-voltage wire to this assembly

immediately behind the metal bracket.

Attach wires to low-voltage terminals at rear of

inlet

valve.

Place inner wall assembly lengthwise through

wall opening and arrange assembly so that

metal bracket is flush with inside surface of

wall. Screw inlet to wall as described previous-

ly in STEP 1, then complete as per (Fig. 16).

f) Wall Valve Installation—New Construction

Select a probable location for inlet valve and

drill a pilot hole in the floor. Go below to check

that tubing path is clear of present, or future,

obstructions such as floor joists, heating ducts,

plumbing, wires, etc.

At intended inlet valve location, drill a 2-1/4"

(5.7cm) diameter hole through sole plate. To

pinpoint center of hole, measure over 2"

(5.1cm) from side of stud and 2" (5.1cm) from

front of sole plate (Fig. 17).

Glue a length of tubing into a stud-mounting

bracket assembly. Cut a length of low-voltage

wiring, bring approximately 6" (15.24cm)

through top wire guide hole in stud bracket

assembly and double it back into elbow hole.

Tape wire to tubing at assembly elbow and

again close to end, and tuck remaining wire

into bottom of tubing.