- ページ 2
ラック＆スタンド Atlas PA702-RMKのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Atlas PA702-RMK 2 ページ。 Rack mount kit for amplifier model pa702
ページを印刷するPA702-RMK
Configuration #2 - Mounting of two PA702 amplifiers.
1. Remove amplifier from electrical source.
2. Remove the four feet.
3. Align and secure two chassis joiner plates with the enclosed screws to the top of units. Note: Must install both
plates, one towards the front and one towards the back.
4. Locate the two open holes on each side of the amp located towards the front panel.
5. Align the enclosed rack mount ear to the chassis holes located in step 2.
6. Use the enclosed chassis screws to attach the rack ears to the chassis. Secure firmly, do not over tighten. Repeat
step for opposite chassis side.
7. Disregard extra pieces.
8. Ready for rack installation. Note: It is important the amplifiers have the proper clearance around it for proper
heat dissipation. Always allow at least 1.75" around the amplifier for to assure safe operation. Never mount
an amplifier in an enclosed air tight rack. All racks must have air vents on all sides or forced air cooling to
assure proper heat dissipation.
PA702-RMK Kit Contains:
•
Qty 2
Rack Ears
•
Qty 4
Rack Ear Chassis Screws
•
Qty 1
Rack Extension Plate for Single Unit mounting
•
Qty 2
Screws to combine Extension Plate to Rack Ear
•
Qty 2
Nuts for Screws to secure screw to Extension Plate and Rack Ear
•
Qty 2
Top Joiner Plates
•
Qty 8
Top Joiner Plate Screws
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •
©2007 ATLAS SOUND LP
INSTALLATION INSTRUCTIONS
Specifications are subject to change without notice
AtlasSound.com
Printed in U.S.A.
TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
00406
ATS002689 RevA 03/07
PP