- ページ 3

エアクリーナー Airtecnics DIF-PURのPDF インストレーション、オペレーション、メンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。Airtecnics DIF-PUR 13 ページ。

A complete range of units of f iltration, lightweight, versatile, and easy to install that provide a located climax

f ree of particles exactly there where it is needed. The concrete class of areas inside a cleaning room are

increased. Installed inside vinyl transparent air curtains, sectorize and isolate the working zone f rom external

pollution.

They include an adaptative regulator that maintain a constant f low meanwhile the f an can spin f aster.

The equipment come painted in RAL 9016. However, there is the option to order it in stainless steel.

These equipments are ready f or a suspended and adaptative installation in f alse ceilings with T prof ile.

Besides, they count with a sealed system made with neoprene gasket.

The DIF-PUR models f eature of f our or six f ixations points to ceiling. It must be considered to maintain a

minimum distance of 400mm f or the f ixations of the pref ilter G4 and the connections of the equipment.

Assembly, connection and disconnection, electrical wiring and maintenance must be

carried out exclusively by qualified personnel, observing these instructions and in

accordance with applicable standards. In case of providing special control, a specific

manual is attached that should be used for its operation and installation.

It is not needed to open the service dashboard to connect your device. All connections

(power and control) and necessary bindings are exterior (located on the side of the

equipment). The equipment has a service panel for repairs and replacements (see repairs

section).

To connect the power to the device, there is a white connection box located on the outside of the equipment

(top, next to the pref ilter). You do not need to open the inlet grille to connect it. 230V single-phase current

must be connected to power the f an.

Regulator

connection

0-10V and

dirty f ilter signal.

Dif -PUR models include a constant f low regulation inside a black box located on the outside of the equipment

(next to the power connection box). You do not need to open the drive gate to make the connection.

It is necessary to connect the 0-10V controller and the dirty f ilter visual signal in the power connection box

(see electrical diagram section f or both cases).

DIF-PUR

(3) – Air purification unit – Dif-Pur

Current

connection

Single phase

230V