- ページ 10

ドリル Atlas Copco LCD 1500のPDF 安全および取扱説明書をオンラインで閲覧またはダウンロードできます。Atlas Copco LCD 1500 20 ページ。 Hydraulic core drill

ページを印刷する

Safety and operating instructions

WARNING Involuntary start

Involuntary start of the machine may cause injury.

Keep your hands away from the start and stop

►

device until you are ready to start the machine.

►

Learn how the machine is switched off in the event

of an emergency.

►

Release the start and stop device immediately in

all cases of power supply interruption.

Whenever fitting or removing the insertion tool,

►

switch off the air supply, bleed the machine by

pressing the start and stop device and disconnect

the machine from the power source.

WARNING Whipping hydraulic hose

Hydraulic hoses under pressure can whip

uncontrollably if screws loosen or are loosened. A

whipping hydraulic hose can cause severe injuries.

►

Depressurise the hydraulic system before

loosening the connection of a hydraulic hose.

Tighten the nuts on the connections of the

►

hydraulic hoses to the required torque.

Check that the hydraulic hose and the connections

►

are not damaged.

WARNING Noise hazard

High noise levels can cause permanent and disabling

hearing loss and other problems such as tinnitus

(ringing, buzzing, whistling, or humming in the ears).

To reduce risks and prevent an unnecessary increase

in noise levels:

►

Risk assessment of these hazards and

implementation of appropriate controls is essential.

Operate and maintain the machine as

►

recommended in these instructions.

Select, maintain and replace the working tool as

►

recommended in these instructions.

►

If the machine has a silencer, check that it is in

place and in good working condition.

Always use hearing protection.

►

Use damping material to prevent work pieces from

►

'ringing'.

Maintenance, precautions

WARNING Machine modification

Any machine modification may result in bodily injuries

to yourself or others.

►

Never modify the machine. Modified machines are

not covered by warranty or product liability.

►

Always use original parts, cutting blades/working

tools, and accessories.

Change damaged parts immediately.

►

Replace worn components in good time.

CAUTION Hot working tool

The tip of the working tool can become hot and sharp

when used. Touching it can lead to burns and cuts.

Never touch a hot or sharp working tool.

►

Wait until the working tool has cooled down before

carrying out maintenance work.

WARNING Working tool hazards

Accidental engagement of the start and stop device

during maintenance or installation can cause serious

injuries, when the power source is connected.

Never inspect, clean, install, or remove the working

►

tool while the power source is connected.

Storage, precautions

Keep the machine and tools in a safe place, out

♦

of the reach of children and locked up.

LCD 500, 1500

Original instructions