ページを印刷するSpecial Tools
Torx screwdriver TX 30
Required
Forcing disks
Adjustment tool for carbon brushes
Pulling-off device
Tool for dis-/assembly of the spindle (PHE 6 H)
Important!
Before beginning the maintenance work, perform an initial check with a high voltage test according
to VDE (see chapter Electrical and Mechanical Test Instructions).
Before all repair work, pull the power plug from the socket!
Before disassembly, the machine must be connected to the RTR-READER (maintenance measuring in-
strument) in order to check for a possible maintenance interval.
Disassembly
1
PHE 6 S:
Remove the auxiliary handle (G) com-
Dismantling the
pletely with the clamping ring (F).
tool reception
2
Push back the rubber cover (2) and re-
move the end cover cap (1).
3
Remove the spring ring (3).
4
Remove the stop (4), the rubber stop (5)
and the retainer (6).
5
Depress the retention plate (8) against re-
silience - the latches (7) are relieved. Un-
screw the latches (7) and remove them
(see illustration 1).
6
Remove the retention plate (8), the
spring (L) and the washer (K).
7
Take out the restrictor (J).
8
Remove the cone (H).
9
Loosen the bearing bolt (9). Keep the ten-
sion and carefully remove the clamping
ring (E).
10
Peel off the connecting ring (D).
11
Unscrew both screws (B). Slightly lift the
switch lever (C) and pull out the retaining
strap (A). Remove the switch lever (C).
1
PHE 6 H:
Remove the auxiliary handle (C) com-
Dismantling the
pletely with the clamping ring ring (B).
tool reception
2
Remove the dust guard cap (3).
3
Expel the latch (8) from the nosepiece with
aid of a mandrel.
4
Remove the latch (5), the spring (4) and
the distance sleeve (6).
5
Take out the restrictor (1).
6
Pull off the cone (2).
7
Loosen the bearing bolt (9). Keep the ten-
sion and carefully remove the strap (A).
8
Peel off the connecting ring (7).
Repair Instructions No.181.03/98
4932 319 998
4931 599 018
9170 302 270
9170 314 440
9170 302 260
1
2
L
K
5
4
3
2
1
PHE 6 H / PHE 6 S
7 8
4
5
6
3
9
E
D
C B
F
J
H
G
7
6
9
A
B
C
PAGE
1
A
1
2
8