ページを印刷する
Operating Instructions
Figure 9
Using a parallel effects
connection
21
Using parallel effects connection with the PS1 power stand
Note: Connecting an effects unit in parallel requires one ¼-inch unbalanced (instrument) cable,
one mono ¼-inch phone (M) to dual mono ¼-inch phone (F) "Y" cable adaptor, and one TRS split
"insert" cable (with a ¼-inch TRS connector on one side and two mono ¼-inch phone connec-
tors on the other).
1. Insert the TRS plug into the Channel 1 Insert jack on the PS1 power stand.
2. Connect both ¼-inch plugs from the "insert" cable into both receptacles on the "Y" cable
adaptor.
3. Connect the plug of the "Y" cable adapter into the input of the effects processor.
4. Connect the ¼-inch unbalanced (instrument) cable from the output of the effects
processor to Channel 3 Line IN of the PS1 power stand.
5. Set the effects level of the processor to full and turn the mix level of the effects processor
to full "wet".
6. Adjust the Channel 3 Level control of the PS1 power stand for the desirable effects mix.
1/4-inch Instrument Cable
Connect to
Connect to
Channel 1 Insert
Channel 3 Line IN
PS1 power stand
TRS split "insert" cable
Connect to Effects
Unit OUTPUT
Mono 1/4-inch Phone (M) to
dual mono 1/4-inch Phone (F)
"Y" cable adaptor
Connect to Effect Unit INPUT
Digital Effects Unit