- ページ 11

水ポンプ Annovi Reverberi AR 80 bp SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Annovi Reverberi AR 80 bp Series 18 ページ。

Pump Storage

It is important to comply with the recommendations for storage in the operator's manual of the machine

into which the pump is incorporated.

For the pump itself, at the end of pumping operations it is essential to flush out the pump by pumping clean

water. After this, open the pump inlet to air and leave the pump in operation until the pump is completely

empty. Following this simple procedure at the end of every operating session will prevent the retention

inside the pump of products which are often corrosive and may damage its wetted parts over the long-

term.

If the pump is in storage during the winter in locations with severe weather conditions, it is very important to

flush out the internal circuit as described above and then fill the pump with A/R Pump Saver, AR64511. Then

take care to drain the liquid from the system and the pump.

Putting the pump back into service

Before putting the pump back into service after storage, check the oil level and the tightness of the

mounting screws.

Scrapping the pump

Used units must be disposed of in compliance with local legislation.

A/R Pump Saver

P/N 64511

Protects Pumps from

Freezing Conditions