- ページ 8

ウォーターヒーター Airthereal Evenfall EVF6YLのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Airthereal Evenfall EVF6YL 16 ページ。 Portable propane tankless water heater for outdoor

ページを印刷する

Preparation

ONLY USE IN OUTDOOR AREAS. CARBON MONOXIDE HAZARD-USING THIS APPLIANCE IN

AN ENCLOSED SPACE WILL CAUSE DEATH-DO NOT USE IN CARAVANS, TENTS, MARINE

CRAFT, CARS, MOBILE HOMES OR SIMILAR LOCATIONS.

1. Use appliance only with LP (propane) gas and the regulator valve assembly supplied.

Note:

LP gas supply cylinders to be used must be:

Constructed and marked in accordance with the specifications for LP gas cylinders of the Tubes

●

for Transportation of Dangerous Goods and Commission, CAN/CSA-B339, as applicable.

Provided with a listed overfilling prevention device.

●

Provided with a cylinder connection device compatible with the connection Installation must

●

conform with local codes or in the absence with National Fuel Gas Code, ANSI Z223.1/NFPA 54,

or the Propane Installation Code, CSA B149.1, or the Propane Storage and Handling Code, CSA

B149.2.

2. Reinforcement of the wall is required where the unit is installed so the wall will be strong enough

to hold the water heater. The mounting location for the water heater should allow for easy access

and operation.

3. Take the appliance out from the carton box and remove the foam and plastic bag, position the

upper mounting bracket and partially install the center mounting screw. Hang the upper bracket

on the screw or hang it by handle for temporary fixed.

Wall Mount:

Note: Keep this appliance away from all combustible material. Minmum clearances rear at 20 inch,

two sides at 40 inch, top at 40 inch.

Measure all distances to ensure the proper position, mark the position of 3 pilot holes (1 mounting

●

hole for the top mounting hook; 2 pilot holes for the bottom hook)

Use a hammer drill to drill those three holes. Always use eye and ear protection when using a

●

hammer drill.

Insert the sleeve anchor into the mounting hole and two expansion bolts into the bottom two

●

holes. Fix the sleeve anchor bolt and two expansion bolts with a hammer

Hang and attach the water heater through the sleeve anchor

●

Use a wrench to turn the nut until snug. This will pull the stud up through the sleeve expanding it

●

against the wall of the base material

Screw down two 4*30 screws into the bottom two pilot holes to fix the water heater in place.

●